There is so much attention to the location of the hinge installation?

Door and window hardware according to its use functions are: hinges, door closers , positioners , locks, handles and handles, curtain rails and windshield at the bottom of the door. Hinge (hinge) is a commonly used hardware accessory in home decoration. It has a wide variety of products. The following five parts manufacturers introduce the orientation of different doors.

Azimuth of the pipe door hinge device: Generally, one hinge of each device in the up and down direction of the door is at one third of the door. This type of door hinge device orientation method is also the most common device method today, and the force point is relatively uniform.

Ordinary door hinge device orientation: The device is in different orientations, and its force point will also be affected. Generally, the orientation of the ordinary door hinge device is about one quarter of the door, so that the force can be evenly distributed. It also does not affect the switch of the door and daily use.

Door hinge device orientation standard: Different doors also have different heights and thicknesses, so the orientation of the door hinge device also changes with it. Therefore, there is no standard for the orientation of the door hinge device, which is carried out with most of the installation methods of the mall. For example, the door is 2 meters high. When the device is hinged, the upper partition door is 18 cm apart, and the lower spacing of 20 cm is the better door hinge device orientation. If it is an ordinary door, it is necessary to refer to the orientation of other door hinge devices in the room, so as to achieve the overall uniform and beautiful decorative effect, so that each door will make the force point uniform due to the hinge device.

Door hinge device orientation: One hinge can be placed at each of the upper and lower points of the door, two hinges occupy the upper and lower third orientation, and the other hinges the relative orientation device.

Other door hinge device orientation: Glass hinges are suitable for installation on glass doors without frames, and the thickness requirements for glass doors must not exceed 5 mm or 6 mm. If these other hinges cannot find the orientation of the door hinge device, it is possible to use the above-mentioned door hinge device orientation methods. For these hinges, it is also possible. The main thing is to consider whether the force points of the door are even. .